Flat Package Ic Removal Procedure - Panasonic KX-FP80C Service Manual

Temperature of Copper Rod 662 ± 50°F (350 ± 10°C) / (An expert
may handle a 60~80 W iron, but a beginner might damage the foil
by overheating.)
- Flux / HI115 Specific gravity 0.863 / (Original flux should be
replaced daily.)

5.2. FLAT PACKAGE IC REMOVAL PROCEDURE

1. Put plenty of solder on the IC pins so that the pins can be
completely covered.
Note:
If the IC pins are not soldered enough, you may give pressure to the P.C. board when cutting the
pins with a cutter.
2. Make a few cuts into the joint (between the IC and its pins) first
and then cut off the pins thoroughly.
141