Table of Contents
Advertisement
If you want to start the recording of the Style with an introduction, press the
[INTRO] button to preset the Intro.
4. Start to record the notes you play.
The Key Start function triggers the Style accompaniment patterns when you
play a chord on the keyboard below the split point. If you play a note or chord on
the upper part of the keyboard, only the drum track will be triggered.
5. While playing, use the Fills, change the Variation, change Voices for the Upper
and Lower sections, activate/deactivate Dual mode, etc.. Whatever you do will
be captured by the sequencer.
6. Stop the recording with the [START/STOP] button.
You can also stop the recording with an ending by press the [ENDING] button.
7. Press the [RECORD] button to deactivate the sequencer.
At this point, you will have recorded a sequence consisting of a melody line with
accompaniment.
You can choose record the Melody 2 track or leave it 'empty', according to your
requirements.
To record the Melody 2 track, press the [RECORD] button then press the
[MELODY 2] button.
Start the recording by playing on the keyboard. When you have finished, press
the [RECORD] button again to stop the sequencer.
Listen to the playback of a recorded Song
8. Press the [PLAY/STOP] button to listen to the playback of your recording.
While the recorded sequence is playing, you can play along using any voice.
Simply select the one you want and play.
Before starting, you can deactivate one or more recorded tracks. For example,
if you have recorded the Accomp and Melody 1 tracks, you can deactivate the
Melody 1 track to playback the Accomp track only.
The recorded sequence remains in memory even after turning the instrument
off. When you turn on again, the LEDs of the recorded tracks will be shown on.
Record a new song
To record a new Song and cancel the old, simply press the [RECORD] button and
the buttons you want to record. For example, if the ACCOMP and MELODY 1 but-
tons already contain recorded notes (LED on), press the [RECORD] button, then
press the [ACCOMP] and [MELODY 1] buttons. All the LEDs will start to flash,
indicating that the sequencer is set to record mode.
Proceed to record your new song using the method already described. The old
song will be overwritten (cancelled).
If you press [PLAY/STOP] when the sequencer contains no recorded notes, the
display will show a large black dot on the right of the Tempo reading.
Panel Reset - Restore Sequencer
You can cancel a recorded sequence in a single step using the PANEL RESET
procedure. Refer to the "PANEL RESET" operation described on page 17.
18 GK330 Owner's manual
Flashing LEDs
Hide quick links:
Advertisement
Table of Contents
