Larson Electronics EXPCMR-IP-POE Series User Manual And Quick Start Manual page 4

The Explosion Proof Network IP cameras are usually installed on a network in either of two ways:
Connected to the internal switch of a network video recorder (NVR): In this configuration, Ethernet cables connect
the camera directly to an NVR back panel. The NVR automatically "Activates" the camera and configures the camera's
network parameters to establish a communications link between them. In the diagram below, IP Cam A is connected to
the NVR which activates the camera and sets up its network parameters.
Connected to a PoE Network switch: In this configuration, Ethernet drop cables connect the camera to a network
switch. The network utility, SADP Tool, is used to "Activate" the camera and configure the camera's network parameters
so that the camera can communicate across the network. In the diagram below, IP Cam B and IP Cam C are connected to
the router, and are activated with the SADP Tool on Computer B.
In the diagram above, NOTE that:

Computer A cannot directly access any devices within the router firewall (with a browser) unless the device
activated and setup with network parameters compatible with the router, and the router is configured for port
forwarding to the device.

Computer B with SADP Tool is used to activate cameras connected directly to the router (IP Cam B, IP Cam C)
and setup their network parameters. After devices on the router are activated and configured for the network,
Computer B can access each device using Internet Explorer or by reloading the page in Internet Explorer mode
in the Edge browser.
This guide provides generic instructions for activating and setting up the network parameters for new cameras Connected
to the network switch using the SADP Tool. The examples shown herein activate a camera and configure its network
settings. Currently, the procedure is identical for all new network attached IP cameras.
About the SADP Tool
The SADP Tool is a PC-based network utility for discovery of compatible devices on an IP network. It provides an easy
way to activate devices, configure camera and record network configuration settings, and set device passwords. It can be
installed on a Microsoft Windows operating system that has access to the IP network where your devices are installed.
Larson Electronics, LLC
Phone: (877) 348-9680 Fax: (903) 498-3364
IP Camera Network Setup Guide
www.larsonelectronics.com
4 of 10