Frigidaire Gallery GRMS2773AF Use & Care Manual page 30

30
FILTER REPLACEMENT
More about the Advanced
Water Filter
Tested and certified to NSF/
ANSI Standards 42, 53, 401
and CSA B483.1 the the
reduction of claims specified
on the performance data
sheet. Visit Frigidaire.com for
more information.
Do not use with water microbiologically
unsafe or of unknown quality without
adequate disinfection before or after the
system. Use systems certified for cyst
reduction on disinfected waters that may
contain filterable cysts.
Test & certification results:
• Rated Capacity - 125 gal/453 L for
PurePour PWF-1 ice and water filter
• Rated service flow - .50 gal/min.
• Operating Temp: Min. 33°F, Max. 100°F
• Maximum Rated Pressure - 100 lbs/in
• Recommended Minimum Operating
Pressure: 30 lbs/in
Replacing Your Water Filter:
You do not need to turn the water supply
off to change the filter. Be ready to wipe
up any small amounts of water released
during the filter replacement.
1. Turn Off the ice maker(s).
2. Pull the water filter cover forward
and the cover will drop down to
allow access to the filter.
3. Remove the filter by pushing on
the end/face of the filter (you
should hear a click as the cartridge
disengages the snap-in connector).
2
4. Slide the old water filter cartridge
straight out of the housing and
discard it.
5. Unpack the new filter cartridge.
Remove the 2 clear plastic cap
covers on the filter connector. Using
the alignment guide, slide the filter
gently into the filter housing until it
stops against the snap-in connector
at the back of the housing.
6. Push firmly until the cartridge snaps
into place (you should hear a click as
the cartridge engages the
snap-in connector).
7. Press a drinking glass against the
water dispenser while checking for
any leaks at the filter housing. Any
spurts and sputters that occur as
the system purges air out of the
dispenser system are normal.
8. Push the cover up toward the liner.
Then push the filter cover toward
2
the rear of the cabinet. The filter
cover will snap back into place.
9. After filling one glass of water,
continue flushing the system for about
4 minutes. See Priming the water
supply system for more information
10. Once you have properly installed the
filter, reset the filter status on the
display. Press and hold Water Filter
for 3 seconds to delay the alert.
11. Turn on the ice maker(s).