Table of Contents
Advertisement
1 INTRODUZIONE
1 INTRODUCTION
1.1 The manual
The user guide is the document that accompanies the valve from the time of its construction and throughout the period of
use, it is therefore an integral part of the valve. It requires reading the manual before taking any action involving the valve. The
manual must be readily available for use by staff and maintenance of the valve. The user and the attendant use are required
to know the contents of this manual.
Reproduction of any part of this manual, in any form, without the express written permission of DAV Tech. The text and
illustrations in this manual are not binding, the DAV tech reserves the right, at any time and without notice, the right to make
any changes to improve the product or for reasons of character manufacturing or commercial.
1.2 Warranty
The warranty is valid for a period of 12 months from the date of commissioning and no later than 15 months from the
date delivery. The interventions carried out during the warranty period does not extend in any way the validity period of the
guarantee. The seller is not liable for defects caused by normal wear of parts which by their nature are subject to wear.
1.3 Goods receiving
The original configuration of the component must never be changed.
Upon receipt of the goods, check that:
• The packaging is intact
• The exact correspondence of the material ordered.
2 TECHNICAL DESCRIPTION
Operation of the pressure reducer
DAT 096 pressure regulators are used for manual adjustment of fluid pressure.
They are available in pressure ranges of 0 - 7 bar, 0 - 25 bar and 0 - 50 bar. These regulators are made of stainless steel. In this
way they are suitable for most fluids f.i. glues, adhesives, colors, varnishes, release agents, oils.
The diaphragm is made of Viton®, resp. the material of the diaphragm on the side is made of PTFE. The diaphragm of the
0 - 50 bar regulator is also made of a special fabric. The valve balls are made of ceramic.
Technical specification
Model
Diaphragm
Gasket material:
Inlet pressure
Manometer:
Connections:
Material:
PRESSURE REDUCER DAT096
DAT 096
Viton® / PTFE
Viton®
0 - 7 bar = max. 40 bar
0 - 25 bar = max. 40 bar
0 - 50 bar = max. 70 bar
Stailess steel ø 63mm
1/2"
Stailess steel
. 3
pag
Advertisement
Table of Contents
