Table of Contents
Advertisement
Installation and maintenance guide
4 INSTALLATION
WARNING! Risk of injury!
Hydraulic energies can cause serious injuries. If a component is damaged, high pressure
materials can escape and cause injury and damage!
The material pressure regulator can be installed in
any position.
Screw the material pressure regulator tight and
tight!
For screw connection of the material pressure
regulator, there are four M6 threads located under
the device.
To avoid damage to connected devices on the
outlet side, a safety valve can be integrated into
the hose, which allows any pressure exceeding the
permissible level to safely escape.
4.1 Hose installation / Pipe installation
How the pipe or various hoses are installed depends on the size of the pipe and the type of connections.
WARNING! Risk of injury due to material pressure!
Only qualified personnel may work on the material pressure regulator in compliance with the
safety regulations.
When working on the material pressure regulator, be sure to:
> Depressurise the regulator before starting work
> Do not remove or disable safety devices.
> Do not set pressures higher than the maximum allowed values.
> Install all hoses securely so that the pressure lines cannot be damaged by moving parts of
the machine or system.
> Do not start the material pressure regulator until the work is finished.
IMPORTANT!
!
Only supply cables, lines, hoses and screw connections may be used which are designed and constructed
in accordance with the applicable regulations. They must be designed to withstand the thermal, chemical
and mechanical stresses expected during operation.
Fig. 4/1
Advertisement
Table of Contents
