Table of Contents
Advertisement
Installation and maintenance guide
5 OPERATION
5.1 General and safety instructions for operation
In normal operation the material pressure regulator requires no operating personnel. To avoid failures, the function of the
material pressure regulator must be checked regularly by qualified inspectors.
Regular monitoring of the outlet pressure will prevent damage to devices connected to the outlet side caused by
overpressure.
!
IMPORTANT!
In the event of malfunctions or irregularities, switch off the material pressure regulator immediately.
In the event that the faults cannot be eliminated (see chap. 6.2 "Faults"), inform the customer service of the manufacturer.
Use only trained personnel for regular cleaning.
The product presents the following dangers during operation:
WARNING! Risk of injury!
If used incorrectly, there is a risk that fluids will be sprayed under high pressure.
WARNING! Risk of injury!
The material pressure regulator should never be opened until the pressure has been fully
released.
WARNING! Danger of burns!
All components of the material pressure regulator can become hot during operation. Wear
suitable protective clothing (gloves, etc.)
5.2 Shutdown
Before switching off the appliance for a long time, the following operations must be carried out in compliance with the
safety regulations:
> Depressurise the connected lines.
> Unmount Lines
> Remove material residues from the device.
> Clean the device inside and out. (Observe chapter 6 "Maintenance and service").
Advertisement
Table of Contents
