Troubleshooting - D-Link DSL-224 Quick Installation Manual

To configure the wireless network, go to the Wireless network settings wizard page in the
Home section or to the Basic settings page in the Wi-Fi section.
For detailed description of every page of the web-based interface, see the "User Manual" document
on D-Link website (see www.dlink.ru).

TROUBLESHOOTING

Question 1. How do I reset the router to the factory default
settings?
Also you can restore the factory default settings via the hardware RESET button located on the left
side panel of the router.
1. Use a small paperclip to activate the button; insert it into the hole (with the device turned
on), push, and hold for 10 seconds.
2. Release the button and wait until the router is rebooted (about a minute).
This procedure wipes out all settings that you have configured for your router. You can access the
web-based interface of the router and configure all needed settings using the default IP address,
username, and password (see the Connection and Configuration chapter of the present document).
Question 2. What can I do if my router is not working
correctly?
Below are some steps applicable to the most common issues.
1. Check the LEDs on the front panel of the router. The following LEDs should be solid or
blinking green: POWER, LAN (corresponding to the LAN ports of the router to which
devices from the router's local area network are connected), DSL, WLAN (if the wireless
network is on and in use), and INTERNET.
2. Make sure that all cables are connected properly.
3. Power off the router for 20 seconds, then power it on again.
Question 3. Why am I unable to connect to the Internet?
Contact your ISP to make sure that the relevant service is available and that you use correct
connection settings.