Assembly; Installation - Klarstein KINGSVILLE 3.1 Manual

ASSEMBLY

Make sure your grill is assembled correctly. Each grill comes with detailed
assembly instructions that include assembly procedures specifi c to each model.
Follow these instructions carefully to ensure the correct and safe assembly of the
grill.
CAUTION
Risk of injury! Despite all eff orts to make assembly as easy as
possible, when handling the steel parts it is possible that corners
and edges can cause cut injuries if handled improperly during
assembly. Be careful when handling parts during assembly. It is
strongly recommended to wear work gloves during assembly.

INSTALLATION

Preparation
• To operate this gas grill you need a gas bottle (liquid gas) and a suitable gas
pressure regulator. Regulators should comply with standard EN 16129 (as
amended) and national regulations.
• Connect the hose and regulator to the gas bottle on the left side of the gas
grill, making sure the gas bottle is kept away from heat and in a secure
position.
The hose should have a diameter of 8-10 mm. The recommended length of
the hose is 1.5 m maximum. The fl exible hose should conform to the relevant
standard and local regulations.
Installation
After purchasing a suitable gas bottle, you can set it up with your gas grill.
• Check all parts and make sure that no part is missing. If parts are missing,
contact customer service.
• You will need a suitable screwdriver and spanner for assembly. Only use tools
that are intact and suitable for the task at hand.
• Choose a suitable place to set up the device. Place the device on a fl at,
suffi ciently large surface where it is stable. Make sure the inlet and outlet
regulators are correct and suitable for the gas cylinder valve and the device.
• If the regulator is used outdoors, make sure it is protected from the elements.
• You will need a suitable spanner to connect the gas bottle.
• When connecting the hose, make sure it is not twisted.
EN
29