Assembly; Installation - Klarstein KINGSVILLE SMOKER Manual

EN
28

ASSEMBLY

Make sure your grill is assembled correctly. Each grill comes with detailed assembly
instructions that include assembly procedures specifi c to each model. Follow these
instructions carefully to ensure the correct and safe assembly of the grill.
CAUTION
Risk of injury! Despite all efforts to make assembly as easy as possible,
when handling the steel parts it is possible that corners and edges can
cause cut injuries if handled improperly during assembly. Be careful
when handling parts during assembly. It is strongly recommended to
wear work gloves during assembly.

INSTALLATION

Preparation
• To operate this gas grill you need a gas bottle (liquid gas) and a suitable gas
pressure regulator. Regulators should comply with standard EN 16129 (as
amended) and national regulations.
• Connect the hose and regulator to the gas bottle on the left side of the gas grill,
making sure the gas bottle is kept away from heat and in a secure position.
The hose should have a diameter of 8-10 mm. The recommended length of the hose is
1.5 m maximum. The fl exible hose should conform to the relevant standard and local
regulations.
Installation
After purchasing a suitable gas bottle, you can set it up with your gas grill.
• Check all parts and make sure that no part is missing. If parts are missing, contact
customer service.
• You will need a suitable screwdriver and spanner for assembly. Only use tools that
are intact and suitable for the task at hand.