Using The Device; Procedure 1. Prepare The Scope - GlideScope LoPro S1 Operation & Maintenance Manual

Using the Device

Please read the
Prior to using the device, set up the device according to the instructions in the chapter
verify the setup by completing the procedure
Video batons and Reusable Titanium video laryngoscopes are equipped with the Reveal anti-fog feature,
which reduces camera fogging during the intubation procedure. To fully optimize the feature, you must allow
the video laryngoscope to warm up for 30-120 seconds prior to use, depending on the ambient temperature
and humidity of the clinical environment. Full optimization of the anti-fog feature is not necessary in order to
use the device; if desired, you may begin the intubation procedure immediately.
Note: If the video laryngoscope is stored in cold conditions, additional warming time may be required for
optimal performance of the anti‑fog feature.
This chapter consists of the following procedures:
• Prepare the Scope
○ Option 1: Video Batons
○ Option 2: Reusable & Single-Use Video Laryngoscopes
• Intubate the Patient
○ Option 1: LoPro Blade or GVL Stat
○ Option 2: Mac-Style or Miller-Style Blade
Procedure 1.
IMPORTANT
Ensure that each component has been properly cleaned, disinfected, or sterilized according to the
guidance provided in the
Option 1. Video Batons
Ensure that the video monitor is turned off prior to connecting or disconnecting the video cable.
1. Based on a clinical assessment of the patient and the experience and judgment of the clinician, select
the video baton and GVL Stat combination that is appropriate for the patient.
2. Attach the video cable and video laryngoscope to the monitor, according to the instructions in
Video Cable to the Monitor
3. If you are using a Video Baton 2.0 Large (3-4), attach the baton to the cable, according to the
instructions in
4. Turn on the video monitor.
5. Ensure that the battery is sufficiently charged. If necessary, connect the monitor directly to power.
Operations & Maintenance Manual: Using the Device
Warnings & Cautions
Prepare the Scope
Reprocessing chapter.
on page 18.
Attach the Scope to the Video Cable
section before performing the following tasks.
Perform a Functional Check.
on page 18.
Setting Up, and then
Attach the
21
0900-4940 REV-13