Setting Up; Procedure 1. Perform Initial Inspection - GlideScope LoPro S1 Operation & Maintenance Manual

Setting Up

Please read the
This chapter contains information on connecting a video monitor, video cable, and scope. The video cable
attaches the scope to the monitor, supplying power to the component and transmitting video data from the
scope's camera to the monitor.
Before you can use the system for the first time, you must inspect the components, set up the system, and
perform a functional test as recommended by Verathon. Complete the following procedures:
1. Perform Initial
occurred during shipment.
2. Attach the Video Cable to the
transmits the video signal to the monitor.
3. Attach the Scope to the Video
4. Perform a Functional
ensure that the system is working properly.
Procedure 1.
When you receive a component, Verathon recommends that an operator familiar with it perform a full visual
inspection for any obvious physical damage that may have occurred during shipment.
1. Verify that you have received the appropriate components for your system by referring to the packing list
included with the system.
2. Inspect the components for damage.
3. If any of the components are missing or damaged, notify the carrier and Verathon Customer Care or
your local representative. For contact information, visit verathon.com/service-and-support.
Operations & Maintenance Manual: Setting Up
Warnings & Cautions
Inspection—Inspect components for any obvious physical damage that may have
Monitor—Attach the video cable that provides power to the scope, and
Cable—Attach the scope that houses the camera and light.
Check—Before you use the device for the first time, perform a functional check to
Perform Initial Inspection
section before performing the following tasks.
17
0900-4940 REV-13