Table of Contents
Advertisement
6 HOW TO ATTACH AND DETACH THE DRIVE UNIT
5
Set the zoom/focus operation change-over knobs of the
drive unit to MANU. side, set the iris operation mode
change-over switch to "M" side, and then turn the focus,
zoom and iris ring manually and check gear engagement.
6
Verify that the gear of the drive unit is engaged with the
gear of the lens and tighten the three fixing screws to the
specified torque to fix the drive unit.
* Tightening torque: 63 - 80 N・cm (6.4 - 8.2 kg•cm)
7
Mount the lens on the camera, connect the 12-pin cable,
switch the power on and adjust the mechanical end
automatically on the display.
* For details on how to adjust the mechanical end
automatically, refer to "6-3 AUTOMATIC ADJUSTMENT OF
THE MECHANICAL END" on the next page.
NOTE
If an error message appears on the display when
the power is turned on, contact Canon Inc. or Canon
distributers & sales representatives.
E22
Advertisement
Table of Contents
