Table of Contents
Advertisement
1 NOMENCLATURE
1 NOMENCLATURE
⑧
⑦
⑥
⑤
④
③
②
①
㉖
㉕
㉔
㉓
㉒
Information Display (Digital Drive Unit)
For the operation of the digital drive unit, refer to Operation Manual "Information displa
⑪
⑨
⑫
⑩
⑲
⑳
㉗
PL Mount Lens Only
①
②
③
① Iris Gain Adjusting Trimmer
② Focus Ring A
⑬
③ Focus Ring B
⑭
⑮
④ Max. Zoom Speed Adjusting Volume
⑤ Instant Auto-Iris Switch
⑯
⑥ Iris Operation Mode Change-over Switch
⑦ Zoom Rocker Seesaw
⑰
⑧ RET Switch (Video Return Switch)
⑱
⑨ VTR Switch
⑩ AUX Switch
⑪ Flange Back Lock Screw
⑫ Flange Back Adjusting Ring
⑬ Macro Ring
⑭ Macro Button
⑮ Extender Switching Lever
⑯ MEMO Switch (Memory Switch)
⑰ Iris Ring
⑱ Zoom Ring
⑲ Zoom Lever
⑳ Lens Holder
㉑ Attachment Holder Contact Plate
㉒ Tie Cable
㉓ Remote Connectors (20-pin)
NOTE) Only connector ★ can be used as the iris remote
or virtual output port.
Use these connectors to connect the control accessory
(equipped with a 20 pin connector) for zooming or focusing.
Connector ★ has also a function to operate the iris through
㉑
a focus control accessory and a dedicated cable and a
function to interface with various virtual systems. It can
output each positioning signal of zoom, focus, and iris.
㉔ Zoom Operation Change-over Knob
㉕Focus Operation Change-over Knob
㉖ Hood Lock Knob
㉗ Lens Cable Connector (12-pins)
NOTE) PL mount lens only
① Display Switch
Used to turn the display ON/OFF.
② Display
It turns off if left for 2 minutes without operation.
③ Control key
Used to move the cursor up/down/left/right. Press the
center to confirm.
E2
y"
.
Advertisement
Table of Contents
