Table of Contents
Advertisement
2
SETUP AND INSTALLATION FOR 8410 AND 8420
Important
This guide provides important safety information which should be read thoroughly before permanently
installing the product.
See the appropriate section below for mounting either the 8410 or 8420.
2.1
8410 Mounting & Installation
Algo's 8410 IP Display Speaker is a one-sided product intended for flush mounting on a wall. For the ceiling-mount
option more suited to hallways, see the 8420 mounting and installation instructions below.
What is Included
The following items are included with the purchase of this
device:
•
8410 IP Display Speaker
•
Wall-mount bracket
•
Bracket attachment screws (4x 6-32 Flat Head Hex
Drive Machine Screws)
•
Terminal Block Plug
•
5/64" Drive Size Allen Key
•
Getting Started Sheet
2.1.1
Getting Started – Quick Install and Setup
1. Connect the 8410 to an IEEE 802.3at / 802.3bt compliant PoE+ or PoE++ network switch or power injector. See
section 2.4 Power Requirements.
o
The green LED flashers will activate and a small blue light on the bottom below the flasher will remain on
until boot up is completed – about 30 seconds.
o
After a few moments, the screen will show the Algo logo.
2. Once the unit finishes booting, a configuration message with the IP address will appear on the screen if it is in
factory default state. If there is no DHCP server, the 8410 will default to the static IP address 192.168.1.111.
Note
If the IP address does not appear on the screen, press the reset (RST) button to hear the IP address recited over
the speakers. The IP address will be repeated over the speakers until the reset button is pressed again to turn
off.
3. Access the 8410 IP Display Speaker web interface by entering the IP address into a browser and login using the
default password algo.
2.1.2
Installation
The 8410 IP Display Speaker is designed to fit on a wall bracket. Concealed wiring may enter from the wall into the
wiring cavity. Alternatively, surface wiring may enter through a channel from the bottom edge.
AL061-UG-GP258410-001-R0
8420 IP Dual-Sided Display Speaker
What is Not Included
The following items are not included with the purchase of this
device:
•
Ethernet Cable
•
PoE++ Switch
•
Wall bracket screws (#8 screws required as appropriate
for your wall)
support@algosolutions.com
8410 IP Display Speaker &
Page 8
Advertisement
Table of Contents
