Husqvarna R 200iX Operator's Manual page 29

Problem
The cutting result is unsatisfacto-
ry.
Display - Troubleshooting
Display indicator messages
Display indicator messages show an engaged function or information about the condition of the product. Refer to
Display overview on page 4 . One or more display indicators come on. When there is a display indicator message, the
product can still operate but there are recommended actions.
Symbols
1949 - 003 - 28.03.2023
Cause
The blades are blunt.
The grass is long or wet.
The cutting deck is not parallel to
the ground.
There is grass blockage in the
cutting deck.
The tire pressure is different on
the right and left sides.
The product is operated at too
high speed.
The motor speed is too low.
Name Cause / Action
System error There is a system error on the product. Stop the product
and set the power switch to the "0" position. Wait for 5
minutes. Speak to your Husqvarna servicing dealer if the
problem continues.
Battery error There is a battery error. Stop the product and set the power
switch to the "0" position. Wait for 5 minutes before you
start. Speak to your Husqvarna servicing dealer if the prob-
lem continues.
Drive motor warn- The drive motor is stalled. Possibly because the product
ing operates on a hill where the necessary discharge power is
too high. Do not operate in conditions that cause the drive
motor to stop.
Temperature error There is a temperature error. Refer to the combination of
symbols for more information.
Decreased per- Decreased performance mode is on. Decreased perform-
formance mode ance mode is automatically set when the level of charge is
low. Charge the product and do not operate on a hill.
Action
To examine the blades on page 26 .
Refer to
To get a good mow result on page
Refer to
20 .
To do a check of the parallelism of
Refer to
the cutting deck on page 25 .
To clean the product on page 22 .
Refer to
Tire pressure on page 24 .
Refer to
Speak to your Husqvarna servicing dealer.
Speak to your Husqvarna servicing dealer.
29