Husqvarna R 200iX Operator's Manual page 17

Battery indication when the battery
charges
When a charger is connected to the product and the
power switch is set to the "1" position, the display shows
the charge view. Refer to
When a charger is connected, 4 LEDs below the socket
for the battery charger show the state of charge.
Note:
All 4 LEDs come on momentarily when the
battery charger is connected.
CAUTION:
red LEDs flash when the battery charger
is connected, there is an error. Look for
warning symbols or an error message on the
display. Disconnect the charger and refer to
Troubleshooting on page 27 .
When the battery is fully charged, all 4 LEDs are on.
CAUTION:
and the charger ON/OFF switch is set to
OFF, all charge indicators will go off. Make
sure that you disconnect the charger before
you operate the product.
LEDs
All 4 LEDs are on.
LEDs 1–3 are on.
LEDs 1–2 are on.
LED 1 is on.
Note:
If a charger is connected when the temperature
of the battery is higher than 38°C, the charge does not
start. Yellow LEDs show the state of charge. When the
temperature of the battery is in the permitted charge
1949 - 003 - 28.03.2023
Charge view on page 5 .
If no LEDs come on or if
If the charger is connected
State of charge
The battery is 76–100%
charged.
The battery is 51–75%
charged.
The battery is 26–50%
charged.
The battery is 0–25%
charged.
temperature range (0-38°C), the charge automatically
starts.
Note:
If you use the product in cold temperatures, the
operation time can decrease.
To disconnect the battery charger
Note:
It is not possible to start the product when the
battery charger is connected.
1. Set the charger ON/OFF switch to OFF.
2. Turn the charger plug to disconnect the charger.
To adjust the seat
The seat can be tilted forward. It can also be adjusted
lengthways. Loosen the handles below the seat to adjust
it forward or rearward.
To adjust height of the steering wheel
WARNING:
the steering wheel during operation of the
product.
Do not adjust the height of
17