Husqvarna R 200iX Operator's Manual page 28

Problem
The battery does not charge. The
LEDs below the socket for the
battery charger do not come on.
The battery does not charge. The
LEDs below the socket for the
battery charger flash red.
The battery does not charge. The
LEDs below the socket for the
battery charger show the state of
charge in yellow.
The operation time is not in-
creased after a second battery is
installed.
There is vibration in the product
during cutting mode.
There is vibration in the product
during transport mode.
28
Cause
The battery charger is not cor-
rectly connected to the mains
outlet or to the product.
The charger ON/OFF switch is
set to OFF.
The battery charger is broken.
There is an internal error.
The mains outlet is broken.
The temperature is not in the
charge temperature range.
The battery is broken.
There is an internal error.
The battery temperature is higher
than 38 °C.
The second battery is not cor-
rectly installed in the product.
The blades are loose/damaged.
One or more blades are not bal-
anced.
The cutting deck motor is loose.
One or more wheels are loose.
The product has a flat tire.
There are loose screws in the
product.
The drive motor is loose.
Action
To charge the battery on page 16 .
Refer to
Set the charger ON/OFF switch to ON.
Disconnect the battery charger and speak to
your Husqvarna servicing dealer.
Put the charger plug into a mains outlet that
has the voltage and frequency that is speci-
fied on the rating plate.
Wait until the battery temperature is in the
permitted charge temperature range (0-38
°C). Look for error messages or warning
symbols on the display. Refer to
messages on the display on page 30 and
Error messages on the display on page 30 .
Disconnect the battery charger and speak to
your Husqvarna servicing dealer.
Make sure that the charger and the product
is in a location that is in the permitted charge
temperature range (0-38 °C). If the charger
is connected, the charge starts automatically
when the battery temperature is lower than
38 °C. If the problem continues, speak to
your Husqvarna servicing dealer.
Make sure that the second battery show on
To read system informa-
the display. Refer to
tion on page 14 . Speak to your Husqvarna
servicing dealer if there is only 1 battery sym-
bol in the display or if the problem continues.
Do a visual inspection. Refer to
the blades on page 26 . Speak to your Husq-
varna servicing dealer if the problem contin-
ues.
Do a visual inspection. Speak to your Husq-
varna servicing dealer if the problem contin-
ues.
1949 - 003 - 28.03.2023
Warning
To examine