Download
Share
Print this page
Marey ECO110 Instruction Manual
  1. Manuals
  2. Brands
  3. Marey Manuals
  4. Water Heater
  5. ECO110
  6. Instruction manual

Marey ECO110 Instruction Manual

Electric instant water heater
Hide thumbs Also See for ECO110:
1
2
3
4
5
6
7

Advertisement

Quick Links

Download this manual

Advertisement

loading
Need help?

Need help?

Do you have a question about the ECO110 and is the answer not in the manual?

Questions and answers

Related Manuals for Marey ECO110

Summary of Contents for Marey ECO110

  • Page 2 INSTALLATION GUIDE Take the time to thoroughly read and understand this safety and installation INSTALLATION manual in its entirety before you attempt to install your new ECO110 tankless RESTRICTIONS water heater, as it contains important safety tips and instructions. ENERGY SAVING TIPS Please carefully read all instructions and warnings.
  • Page 3 II) PLUMBING resetting the unit. Important: Your ECO110 water heater does NOT have a high pressure relief Resetting your unit without turning off the breaker can result in personal injury and valve. Your heater is intended for use ONLY up to 150 PSI of water pressure. When damage to your water heater.
  • Page 4 IMPORTANT: THE BREAKER MUST BE GFCI. THE UNIT DOES NOT HAVE - This unit requires a single dedicated circuit. NO other equipment can be on this AN INTERNAL GFCI CONTROL! FAILURE TO USE A GFCI BREAKER CAN circuit. RESULT IN INJURY OR DEATH. - Turn off the power switch when the unit will be unused for extended periods of -Connect the ground, as indicated in the Electrical Code.

  • Page 5: Technical Specifications

    4. Install screws (with wall anchors if a stud is not available) in the marked locations. Hang the unit from the screws using the keyhole brackets on the back of ECO110 TECHNICAL SPECIFICATIONS the heater. Voltage 220V TEMP.
  • Page 6 - In cooler regions or cooler seasons, the incoming water temperature can cause a variation in the output temperature. The temperature settings on the unit allow you to compensate for flow variations and seasonal changes. Warning:If your water heater requires a reset, be sure to TURN OFF THE BREAKER prior to resetting the unit.

  • Page 7: Power Pak

    6. Tighten the two buttons indicated in the illustration (see Figure 6) and press each one until it clicks. 7. Replace the cover and temperature controller knob. At Marey, we pride ourselves on the excellence of our customer service and ECO110 POWER PAK SANTON support team.