Advertisement
R
epair
[3] DISASSEMBLY/ASSEMBLY
[3] -1. Shear blade complete and Front grip (cont.)
ASSEMBLING
Take the disassembling step in reverse.
Note: • Be sure to set Flat washer 8 and Nylon sleeve 5 in place. (Figs. 7 and 8)
• Align the protrusions of Switch lever B to the slots of Housing set and shift them up (Fig. 9).
Fix them into the depressions by enlarging Front grip.(Fig. 10)
Fig. 9
[3] DISASSEMBLY/ASSEMBLY
[3] -2. Helical gear 67
DISASSEMBLING
(1) Remove Shear blade complete, Nylon sleeve 5 (2pcs), Flat washer 8 and Plane bearing 8. (Refer to pervious page.)
(2) Remove Helical Gear 67 and Spindle as an assembled part, and then remove Flat washer 8 between Helical gear 67
and Bearing box complete. (Fig. 11)
The assembled part can be disassembled by using 1R035 and Arbor press. (Fig.12)
Fig. 11
Bearing box complete
Flat washer 8
an assembled part
of Helical gear 67 and Spindle
ASSEMBLING
Take the disassembling step in reverse.
Note: Be sure to pass Flat washer 8 through Spindle between Gear and Bearing box complete. (Fig. 11)
Spindle and Helical gear 67 are directional in assembling. (Figs. 13 and 14)
Fig. 13
Step of Gear
Spindle
Depression of Housing R
Slot
Protrusion on the end of
Switch lever B
Fig. 12
Arbor press
Helical gear 67
1R035
Spindle
Fig. 14
Spindle
Flat surface
of Helical gear 67
1R035
Fig. 10
Enlarge both ends of Front grip
portion carefully.
Shift up their ends to the depressions.
The assembled part
of Helical gear 67
and Spindle
P 3/ 7
Advertisement
