Electrolux LUT6NF18S User Manual page 33

Problem
The temperature in the ap‐
pliance is too low/too high.
DEMO appears on the dis‐
play.
A or or symbol is
shown instead of numbers
on the temperature dis‐
play.
If the advice does not lead to
the desired result, call the
nearest Authorized Service
Centre.
8.2 Closing the door
1. Clean the door gaskets.
Possible cause
The temperature is not set
correctly.
The door is not closed cor‐
rectly.
The food products' temper‐
ature is too high.
Many food products are
stored at the same time.
The door has been opened
often.
The FastFreeze function is
switched on.
There is no cold air circula‐
tion in the appliance.
The appliance is in the
demonstration mode.
Temperature sensor prob‐
lem.
2. If necessary, adjust the door. Refer
to installation instructions.
3. If necessary, replace the defective
door gaskets. Contact the Authorised
Service Centre.
ENGLISH
Solution
Set a higher/lower temper‐
ature.
Refer to "Closing the door"
section.
Let the food products tem‐
perature decrease to room
temperature before stor‐
age.
Store less food products at
the same time.
Open the door only if nec‐
essary.
Refer to "FastFreeze func‐
tion" section.
Make sure that there is
cold air circulation in the
appliance. Refer to "Hints
and tips" chapter.
To exit the demonstration
mode, press and hold the
OK button for approximate‐
ly 10 seconds until you
hear a long sound and the
display turns off for a short
time.
Contact the nearest Au‐
thorized Service Centre
(the cooling system will
continue to keep food
products cold, but temper‐
ature adjustment will not
be possible).
33