E N G L I S H E N G L I S H - Peavey TKO 115 Supplementary Manual

a. Keep the PROOF OF PURCHASE. In the event warranty service is required during the warranty period, you will need this document. There will be no
identification card issued by Peavey Electronics Corporation.
2. IMPORTANCE OF WARRANTY REGISTRATION CARDS AND NOTIFICATION OF CHANGES OF ADDRESSES:
a. Completion and mailing of WARRANTY REGISTRATION CARDS — Should notification become necessary for any condition that may require correction,
the REGISTRATION CARD will help ensure that you are contacted and properly notified.
b. Notice of address changes – If you move from the address shown on the WARRANTY REGISTRATION CARD, you should notify Peavey of the change of
address so as to facilitate your receipt of any bulletins or other forms of notification which may become necessary in connection with any condition that may
require dissemination of information or correction.
3. You may contact Peavey directly by telephoning (601) 483-5365.
17 18
HIGH GAIN INPUT (1)
Used for most electric basses. It is 6 dB louder than the Low Gain Input.
LOW GAIN INPUT (2)
Provided for instruments that have extremely high outputs, which can result in overdriving (distorting) the High
Gain Input. If both inputs are used simultaneously, the output levels are the same (both are High Gain).
PRE GAIN (3)
Controls the input gain of the preamplifier.
BRIGHT SWITCH (4)
Provides a preset boost (+10 dB) to treble frequencies. To activate, depress the switch to its "in" position.
CONTOUR SWITCH (5)
Defeats the preset special EQ curve when pushed in.
LOW FREQUENCY EQ (6)
An active tone control (shelving type, 15 dB) that varies the low frequency boost or cut.
OPERATION NOTE: Excessive EQ boost, especially of the low frequencies, increases the possibility of
speaker damage, and sacrifices valuable headroom.
HIGH EQ CONTROL (7)
An active tone control (shelving type, 15 dB) that varies the high frequency boost or cut.
GRAPHIC SELECT (8)
The "in" position of this switch routes the instrument signal through the 7-band equalizer. The "out" position
removes the graphic equalizer from the signal path.
E S P A Ñ O L
F R A N C A I S
F R A N C A I S
F R A N C A I S
D E U T S C H
E N G L I S H
E N G L I S H
19
10
17