NightStick TAC-400 Instruction Manual

Instruction Manual
TAC-400/410/450/460
THANK YOU FOR SELECTING THE NIGHTSTICK TAC!
PLEASE SAVE THESE INSTRUCTIONS
Please read these instructions before using your TAC. They include
important safety and operation information. Be sure to charge the TAC fully
before the fi rst use. A battery is fully charged when the charger light is green.
Included in the box - Compris dans la boîte - Incluido en la caja
WARNINGS
Lithium-ion batteries must be used and charged properly. Improper use
can result in serious injury, fi re, or death.
NOT FOR USE IN HAZARDOUS LOCATIONS. Do not use this product
in explosive atmospheres, near fl ammable liquids, or where explosion proof
or intrinsically safe lighting is required.
DO NOT use this product in the proximity of vehicles or equipment when
there is a risk of fl ammable liquids coming into contact with the fl ashlight.
Light can become hot while on. To prevent damage DO NOT cover or
place next to any potentially fl ammable materials while in use.
Do not leave the battery in direct sunlight or use or store the battery inside
cars in hot weather.
Do not expose the battery to water or salt water, or allow the battery to
get wet.
Do not store the battery with metallic objects that may cause a short circuit.
Immediately discontinue use of the battery if the battery emits an unusual
smell, feels hot, changes color, changes shape or appears abnormal in any
way.
Keep out of the reach of children.
INITIAL USE
Fully charge the TAC before the fi rst use, or if the battery is new or has
been unused for several months. The maximum charge time required is
approximately 4 hours.
DAILY USE
Use only the supplied Nightstick charger, battery and AC or DC adapter.
For best performance, charge the TAC when the fl ashlight beam starts to
dim.
Connect the AC power adapter to the charger. The LED indicator will not
be illuminated at this point.
With the fl ashlight facing forward, slide the TAC into the charger until the
contacts snap into place.
The LED indicator changes to constant red indicating the TAC is properly
inserted into the charger and is in fact charging. The LED indicator remains
red until the battery is fully charged. At full charge, the LED indicator turns
green.
The total time to full charge the TAC varies depending on the remaining
charge in the battery pack.
To confi rm a full charge, keep the TAC in the charger and turn it on.
The LED indicator will change to red. Turn off the TAC. If the TAC is fully
charged, the LED indicator will turn green. If not, it remains red until the
charge is completed and the LED indicator turns green. The TAC will now
be fully charged.
OPERATION
The TAC has two light modes: momentary fl ashlight and constant-on
fl ashlight. The TAC has a single tail switch providing access to all modes.
MOMENTARY FLASHLIGHT MODE
Lightly press the tail switch for momentary operation. Release the switch
to turn the light off.
CONSTANT-ON
Press the tail switch until it clicks and then release for constant-on mode.
Press and release the tail switch again to turn the light off.
CR-123 BATTERY CARRIER
The CR123 battery carrier converts the TAC from rechargeable Lithium-
ion to non-rechargeable Lithium battery operation.
Load two CR-123 Lithium batteries with the positive terminals pointing in
the direction of the arrow. NOTE: The fl ashlight cannot be charged with the
CR-123 CARRIER installed.
BAYCO PRODUCTS LIMITED LIFETIME WARRANTY
WARRANTY
Bayco Products, Inc. warrants this product to be free from defects in
workmanship and materials for the original purchaser's lifetime. The Limited
Lifetime Warranty includes the LEDs, housing and lenses. Rechargeable
batteries, chargers, switches, electronics and included accessories are
warranted for a period of two years with proof of purchase. Disposable, non-
rechargeable batteries are excluded from this warranty. Normal wear and
failures which are caused by accidents, misuse, abuse, faulty installation and
lightning damage are also excluded.
In the event that Bayco Products, Inc. receives notice that any product
does not conform to its warranty, the original purchaser's sole and exclusive
remedy, and Bayco Products, Inc.'s sole and exclusive liability, shall be