After Each Use; Maintenance - Klutch 101631 Owner's Manual

1. To remove Shaft 1, remove the Sleeve (#10) off the right end of Shaft 1.
2. Next, at the top of the Left Stand, loosen Hex Bolt (#3).
3. Pull the right end of the Shaft 1 outward.
Remounting Shaft 1
1. Reinsert the right end of Shaft 1 into the hole in the Right Stand.
2. Tighten Hex Bolt (#3) on the top of the Left Stand.
3. Push the Sleeve (#10) onto the end of Shaft 1.
1. Verify that the shafts are clean and free of metal debris.
Maintain the product by adopting a program of conscientious repair and maintenance in accordance
with the following recommended procedures. It is recommended that the general condition of any tool
be examined before it is used. Keep your tool in good repair. Keep handles dry, clean, and free from
oil and grease. The following chart is based on a normal operation schedule.
Maintenance Interval
Every month

After Each Use

Maintenance

Maintenance Point
Check for alignment of moving parts, binding of moving
parts, breakage of parts, mounting, and other conditions that
may affect operation. Any part that is damaged should be
properly repaired or replaced by an authorized service center
unless otherwise indicated elsewhere in the instruction
manual.
Page 8 of 12