Sony HDW-700 Manual page 17

4
Connect the CN1 connector of the SY-247 board to
the personal computer
1) IBM PC/AT or NEC PC-9800 series
personal computer
For settings, refer to Maintenance Manual Part2
Volume1 5-6.
2) For IBM PC/AT personal computer (9 pin)
• RS-232 interface cable : HJ-012/J-6510-120-A
• Jig cable (PCnHJ-012) : HJ-PC9/J-6510-120-2
• Jig cable (HJ-012nSY247) : CN-HJ/J-6510-
110-3
For NEC PC-9800 series personal computer (25 pin)
• RS-232 interface cable : HJ-011/J-6510-110-A
• Jig cable (PCnHJ-012) : HJ-PC25/J-6510-
110-4
• Jig cable (HJ-012nSY247) : CN-HJ/J-6510-
110-3
5
Turn on the power of the HDW-700/700A.
6
Input the following command into the personal
computer to adjust the memory label reader/writer.
"SY247:>TL CHECK[Enter]"
7
Adjust by an adjustment driver.
Note
Confirm that "OK" is displayed on the monitor of
the personal computer.
8
Turn off the power of the HDW-700/700A, then
remove the RS-232 interface jig.
Adjustment point : CT1
Specification : A=MAX (10Vp-p or more)
A1 5.0 V
5 V +↓5 V
1)
by the RS-232 interface jig
V1
A
20 ns
2)
.
7(US)