Cleaning And Maintenance - Pro-Line Boats BL-122 User Manual

CLEANING AND MAINTENANCE

This section provides important information for cleaning and
maintenance of your Pro-line Blender. Please note the following safety
guidelines before and during cleaning:
WARNING: The blades are SHARP! Care must be taken to avoid
personal injury when cleaning
• Always switch off the appliance and remove the power plug from the
socket before cleaning
• Do not immerse appliance in water or any other liquid.
• The Blender Jug is NOT suitable for the dishwasher and should NOT
be fully immersed in water.
• Do not try and dismantle the blades from the container, they are
permanently fixed to the Jug.
To clean Blender Jug
Fill the Blender Jug to no more than the maximum level with warm water
and add a drop of mild detergent. Place onto the Blender Base. Ensure
the lid is securely on and use the Pulse mode until the blender and
blade are clean. Replace the water and repeat if necessary. Pour water
out and dry with a soft cloth. NEVER immerse the whole jug in water.
12 INSTALLATION AND OPERATING INSTRUCTIONS
IMPORTANT: Always ensure the base of the jug is free from water as
it may cause the bearing to rust and affect the performance of the
blender.
The lid and measuring cup can be disassembled and washed in a sink of
warm water, dry thoroughly before use.
To clean the Blender Base
WARNING: Do NOT immerse the Blender base in water or any other
liquid.
Clean the Blender Base with a soft damp cloth only.
NOTE: If water or liquid is left on the Blender Blade, it may cause
discolouration to occur. This does not affect the structure or strength
of the blade.