MODMO SAIGON User Manual page 5

1.3. How to get your E-bike ready for the road
The following section explains how to get your Saigon E-Bike
ready for riding
Required Tools:
• Allen Key 4-5-6 mm
• Spanner
A. Adjusting the Handle Bar
Step 1. Rotate the handlebars until they
are perpendicular to the wheel and frame
B. Inflate the tyres
• Recommendation: 35 – 45 psi. Riding the E-Bike with tyres over or under pressure may result to faster deterioration and/or damage.
• We recommend to check the air pressure regularly every 2 - 4 weeks, as bicycle tubes inevitably loose air over time, especially
when not used regularly.
• The bike tyres are not covered by the warranty. However, in the case of a replacement, we recommend to use of the same
KENDA K1172 tyre or a similar high quality tyre of 40mm width.
Step 2. Tighten the two lateral screws on
the handlebar using the 5mm Allen key
Step 3. Ensure the top-cap is tight but not
too tight as to cause the handlebars to
feel stiff
YOU R B IC YC L E
5