Advertisement
5. Mount the safety wire angle (accessory) on the 2nd anchor bolt and connect the safe-
ty wire (accessory) to the angle.
q Disconnect the safety wire from the
safety wire angle.
w Engage the face marked q with the
anchor bolt.
e Bend the face marked w.
r Connect the safety wire to the safety
wire angle again.
Note: To use the anchor bolt that was already installed, the use of 2 spacer nuts is helpful.
6. Connect the mounting base to the tip
of the safety wire.
Spacer nuts
Anchor bolt
w Insert
q Disconnect
Safety wire
Mark q
Safety wire angle
Safety wire
Safety wire (Accessory)
Mounting base
Upper side
Mark w
e Bend
Lower
side
r Connect
Spacer nuts
Safety wire angle
Existing anchor bolt
Roof space
Insert the mounting
base into the hole
7
Advertisement
