Table of Contents
Advertisement
Chapter 6
6 3
LED Explanation for the Access Point Mode
When the extender works in the Access Point mode, you can check its working status
by following the LED Explanation table below.
Name
Status
On/Off
(Power)
Blinking
2.4G
On/Off
5G
On/Off
Blinking
(Signal)
On/Off
Indication (For Access Point Mode)
The extender is on or off.
The system is starting up or firmware is being upgraded.
The 2.4 GHz wireless band is enabled or disabled.
The 5 GHz wireless band is enabled or disabled.
On
A WPS connection is established.
WPS connection is in progress. This may take up to 2 minutes.
A WPS connection has been established for more than 5
Off
minutes or WPS connection failed.
LAN port 1/2/3 is connected or not connected.
Use Your Extender as an Access Point
36
Advertisement
Table of Contents
