Led Explanation For The Access Point Mode - TP-Link RE230 User Manual

Chapter 6
•
6 3
When the extender works in the Access Point mode, you can check its working status
by following the LED Explanation table below.
Downloaded from ManualsNet.com
Push AP's WPS button: Press the AP's WPS button, then enable WPS on your
device within 2 minutes.

LED Explanation for the Access Point Mode

Name Status
On/Off
(Power)
Blinking
On
Blinking
(Signal)
Off
2.4G
On/Off
(2.4GHz)
5G
On/Off
(5GHz)
search engine
Use Your Extender as an Access Point
Indication (For Access Point Mode)
The extender is on or off.
The system is starting up or firmware is being upgraded.
A WPS connection is established.
WPS connection is in progress. This may take up to 2 minutes.
A WPS connection has been established for more than 5
minutes or WPS connection failed.
The 2.4 GHz wireless band is enabled or disabled.
The 5 GHz wireless band is enabled or disabled.
40