Advertisement
DANGER: To reduce the risk of injury:
• Do not permit children to operate the timer or pool/spa unless
they are closely supervised at all times.
• Test GROUND FAULT protection regularly. If it fails to reset, DO
NOT USE the pool or spa! Contact a qualified service technician.
• Always disconnect electricity before servicing this timer or
the equipment connected to it. THIS TIMER IS NOT TO BE
USED AS A POWER DISCONNECT.
• Use timer only for its intended use as described in this manual.
• Install only on a GROUNDED 120VAC circuit protected by a
fuse or circuit breaker.
How to Set the Timer
1. Insert ON (green) and OFF
(red) trippers into dial at desired
ON and OFF times (Fig. 1). Be
sure trippers are firmly pressed
against dial surface and at least
one space is left between ON
and OFF trippers (Fig. 2).
2. Turn dial clockwise one or
more revolutions until correct
time of day is next to arrow in
center of dial (Fig. 3).
3. Plug pump into timer receptacle
and plug timer cord into outlet.
If timer is used outdoors, outlet
must be suitable for wet locations.
For Early ON or OFF Operation
Turn manual knob counter-clockwise to desired ON or OFF position.
Timer will follow next scheduled automatic operation.
IMPORTANT SAFETY INSTRUCTIONS
SAVE THIS MANUAL
Fig. 1
Fig. 2
Manual Knob
OFF Tripper (Red)
Extra trippers may be stored on
the dial by placing same color
trippers next to each other.
Fig. 3
ON Tripper (Green)
Advertisement
