Mac Mah MEGA UFO-LZR User Manual page 11


Please keep this User Manual for future consultation. If you sell the
fixture to another user, be sure that he also receives this instruction
booklet.

Unpack and check carefully there is no transportation damage before
using the fixture.

It's important to ground the yellow/green conductor to earth in order to
avoid electric shock.

LASER light can cause permanent eye injuries if eyes are exposed to the
laser light.

Disconnect main power before servicing and maintenance.

Maximum ambient temperature is : 40℃. Don't operate it when the
temperature is higher than this.

In the event of serious operating problem, stop using the fixture
immediately. Never try to repair the fixture by yourself. Repairs carried
out by unskilled people can lead to damage or malfunction. Please
contact the nearest authorized technical assistance center. There are no
user serviceable parts inside the fixture except the fuse.

Do not connect the device to any dimmer pack.

To prevent or reduce the risk of electrical shock or fire, do not expose the
fixture to rain or moisture.

Do not look directly at the LASER light beam while the fixture is on.

Do not touch any wire during operation .

The unit should be mounted via its screw holes on the bracket. Always
ensure that the unit is firmly fixed to avoid vibration and slipping while
operating. Always ensure that the structure to which you are attaching
the unit is secure and is able to support a weight of 10 times of the unit's
weight. Also always use a safety cable that can hold 12 times of the
weight of the unit when installing the fixture.

The equipment must be fixed by professionals. And it must be fixed at a
place where is out of the touch of people and has no one pass by or
under it.

Operating Premises: Whenever possible, the operation of a LASER should
be done in a room or in an enclosed or delimited place for this purpose.

The access of room and openings to the outside must not be located in
the axis of a direct beam.

The floor must be free of obstacles. The causes of accidental reflection
11