La Crosse Equity 30022 - 1.4 Led Insta Set Alarm Clock Manual

Table of Contents

OVERVIEW

Insert the 120 volt power cord into an outlet.
The clock will automatically show AM/PM, time, weekday, year, month and date. Default time zone is set to Pacific Standard Time (PST).

Press and release the TIME ZONE button to select one of four Time Zones:

Continuously hold down the TIME button while setting your hour and minutes.
While holding the TIME button, press the HOUR button to set your hour.
Note: The PM indicator will appear when you advance to PM time.
Press the MIN button to set your minutes.
Release the TIME button when the correct time is shown on the display.

Slide the DST ON/OFF Switch to ON. The DST Indicator light will be on. Your clock will move one hour ahead on the Second Sunday in March and move one hour back on the First Sunday in November.
If you do not observe Daylight Saving Time, slide the DST ON/OFF Switch to OFF. Your clock will not change.

Press the MODE button once to view the two digit year. Continuously hold down the MODE button while pressing the HOUR button to set the two digit Year.
Press the MODE button to move to Month and Date settings. Continuously hold down the MODE button while pressing the HOUR button to set the Month, and then press the MIN button to set the Date.
Release the MODE button when the correct Year, Month and Date are selected.

Continuously hold down the ALARM button while setting your alarm time.
While holding the ALARM button, press the HOUR button to set your alarm hour.
Note: The PM indicator will appear when you advance to PM time.
Press the MIN button to set your alarm minutes.
Release the ALARM button when the correct alarm time is shown on the display.

ON: Slide the ALARM ON/OFF switch to the ON position to turn the alarm ON. The Alarm Light Indicator will appear.

OFF: Slide the ALARM ON/OFF switch to the OFF position to turn the alarm OFF. The Alarm Light Indicator will disappear.

When alarm sounds, press the SNOOZE/DIMMER button to silence alarm for 9 minutes. Snooze function can be repeated many times if desired.

The clock has installed one CR2032 battery to maintain the Pacific Standard Time setting.
The battery will keep the alarm and time settings until the power is restored. Alarm will not sound and the LED will not light-up.
To replace the CR2032 battery, insert a screw driver into the slot of the battery holder to remove the old battery. Insert a fresh battery. Positive is face up.

KEEP BATTERIES OUT OF REACH OF CHILDREN

Swallowing may lead to serious injury in as little as 2 hours or death, due to chemical burns and potential perforation of the oesophagus.
If you suspect your child has swallowed or inserted a button battery, immediately seek urgent medical assistance.
Examine devices and make sure the battery compartment is correctly secured, e.g. that the screw or other mechanical fastener is tightened.
Do not use if compartment is not secure.
Dispose of used button batteries immediately and safely. Flat batteries can still be dangerous.
Tell others about the risk associated with button batteries and how to keep their children safe.

Always purchase the correct size and grade of battery most suitable for intended use.
Clean the battery contacts and also those of your clock prior to battery installation.
Ensure the battery is installed with correct polarity (+ and -).
Remove battery from equipment when it is not used for an extended period.
Promptly remove an expired battery.