Panasonic WJ-ND200 Setup Instructions page 35

Camera Setup
Set the recording rate for the SD memory recording for
each channel. Refer to page 40 for further information
about the SD memory recording.
The following recording rates are available for "SD
MEMORY REC". When "OFF" is selected, the SD mem-
ory recording will not be performed for the respective
channel.
OFF/0.1 ips/0.5 ips/1 ips
Notes:
• The recording rate setting for "SD MEMORY REC" is
available only for cameras with the SD memory
recording function and their image compression
method is set to "M-JPEG".
• The recording rate for "SD MEMORY REC" should
be less than the recording rate set for the emer-
gency recording.
When the camera in use is WJ-NT304, recording will
be performed at 0.2 ips even when "0.5 ips" or "1
ips" is selected for the recording rate for "SD MEMO-
RY REC".
• When setting the recording rate for "SD MEMORY
REC", make sure that "Use" is selected for the "SD
memory card" setting of the camera.
When "Use" is not selected or when no SD memory
card is mounted on the camera, error messages
may be displayed several times a day, and recording
may be interrupted for around 20 seconds each time
the error message is displayed.
This may also occur when the firmware of the cam-
era is older. In this case, upgrade the firmware of the
camera.
When the firmware version of the camera in use is
not the version listed below, upgrade the firmware.
Applicable cameras/firmware versions
• WV-NP244 series
• WV-NP1000 series
• WV-NS202
• WV-NF284
• WJ-NT304
• WV-NW484
Important:
When the emergency recording is triggered while
communication with the camera is not established,
the SD memory recording will not be performed.
Ver1.20 or later
Ver1.20 or later
Ver1.00 or later
Ver1.00 or later
Ver1.00 or later
Ver1.00 or later
35