Advertisement
Available languages
Available languages
Attach to the display console
Diagrams appearing on each page are merely illustrative examples; actual products may differ slightly from those shown.
1. Attach the connection cables to the display.
Blankets, soft
cloths or similar.
* Place clean blankets or similar
on a level floor or table,and place
the display on top of them facing down.
2. Insert the poles into the holes
in the display console.
Display console
( Rear of display )
Position the side of the pedestal with the model
no. label to the rear. Push the assembly into the
display until it stops.
Cable Binding Instructions
Bind all cables to the PDP base with the supplied binding strap.
Rear View
Binding strap
Cables
8
Display console
Model no. label
While ensuring there is sufficient slack in the cord to minimize stress,
firmly bind all cables with the supplied binding strap.
Strap anchor
3. Fasten with screws
Long screws
Securely fasten using long screws
* Work on a level and stable surface.
Binding the Cables
Pass the binding strap
through the strap anchor.
Bundle all
cables tidily.
Display console
( Rear of display )
Display console
(Rear of display)
Long screws
Unbinding the Cables
Pull.
Pull.
.
Pull clip.
Advertisement
