Advertisement
Install connections for exhaust, fuel, AC power leads, DC control panel leads, battery, and water
11
through holes in the rear panel as shown in drawing (Figure 5) and as described below:
6
L612 02/05
a. Connect the exhaust elbow of the diesel engine to the exhaust system of the vessel.
Pass the two inch exhaust hose through the opening provided in the left mid-section
of the rear panel.
b. Connect the sea water pump to the vessel's water inlet. Pass a 3/4" hose from the vessel's
sea water strainer through the lower hole at the bottom left of the rear panel to the sea
water pump inlet fi tting.
c. Connect the vessel's fuel supply and fuel return to the generator set using Coast Guard
approved rubber fuel hoses. Pass these lines through the slot provided at the bottom
right of the rear panel and attach them to the generator set's 5/16" hose barb fi ttings.
d. Connect the DC control harness to the engine harness plug. Pass the harness and plug
through the hole at the mid-section of the right side of the rear panel.
e. Connect the 12 volt battery leads to the generator set passing the two leads through the
second hole above the bottom left side on the rear panel.
f. Connect the AC output leads from the generator to the vessel's power distribution panel.
Pass the two leads through the third hole above the bottom left side of the rear panel.
Figure 5: Facing the rear panel.
Advertisement
