Advertisement
14
Install cover panels as shown above.
As you install the panels, observe that there should be a minimum clearance of approximately 1/32"
around the panel perimeter (except at the bottom of the side panels). You may adjust for this by
loosening any number of corner bolting assemblies or toe brackets until fi t is satisfactory. Tighten all
connections when done.
Although preset at the factory, one or more panel latches may occasionally need adjustment. Using
a 1/4" box-end wrench, rotate latch striking bolt one-half turn; counter clockwise to tighten panel,
clockwise to loosen panel.
8
L612 02/05
Advertisement
