Panasonic PAN1026A Design Manual page 12


Min. 15 mm
Antenna "Keep out Area"
The antenna requires a cutout area of 5 mm x 3 mm under the PAN1026A module. This "Keep
out Area" shall be located in every layer under the module antenna.
Impact of Placement on the Antenna Radiation Pattern
It is recommended to verify the perfect position of the module in the target application before
fixing the design.
Design Guide Rev. 1.1
If possible place the module in the
center of mother PCB.
Use a ground plane in the
area surrounding the module
module wherever possible.
Dimensions are in mm.
The placement of the module, surrounding material, and customer
components have an impact on the radiation pattern of the antenna.
5.00 mm
8.7 mm
Keep-Out Area
Top View
PAN1026A Bluetooth Module
3 Reference Design
Min. 15 mm
Page 12