Safety - Husqvarna PE 10J SmartGuard Operator's Manual

Compliance and approvals
Hereby, Husqvarna AB declares that the product is in
compliance with the regulation (EU) 2016/425. The full
text of the EU declaration of conformity is available at
the following internet address: www.husqvarnacp.com;
search for the product.
Responsible manufacturer: Husqvarna AB, SE-561 82
Huskvarna, Sweden, tel: +46-36-146500.
Safety definitions
Warnings, cautions and notes are used to point out
specially important parts of the manual.
WARNING:
injury or death for the operator or bystanders
if the instructions in the manual are not
obeyed.
CAUTION:
damage to the product, other materials or
the adjacent area if the instructions in the
manual are not obeyed.
Note:
Used to give more information that is necessary
in a given situation.
General safety
WARNING:
instructions that follow before you use the
product.
WARNING:
protection against injury.
WARNING:
closed all the way to make the product work
as intended.
CAUTION:
reduce the High-Visibility performance of the
garment.
• Use of this product does not decrease the need for
safe operation of the equipment.
• The protective equipment should only be used
for applications it is intended for. Consult your
supervisor, dealer or Husqvarna for advice if you
are unsure which kind of protective equipment is
required for the application in question.
1953 - 002 - 29.09.2022
Used if there is a risk of
Used if there is a risk of
Read the warning
No PPE can offer full
Main zipper must be
Dirt on the garment will
This product complies with the basic requirements in EU
regulation 2016/425 and is manufactured in compliance
with EN ISO 20471:2013/A1:2016.
Notified body involved in the conformity assessment is:
Number 0402, RISE - Research Institutes of Sweden,
Box 857, 501 15 Borås, Sweden.

Safety

• Use and save these instructions.
• The condition of the protective equipment should be
checked regularly. The garment should be scrapped
and not used again if the protective material has
been damaged, incorrectly washed, altered from
its original shape. The protective qualities may be
reduced in these cases.
• Make sure the product is not damaged during
transportation and use.
• Damaged outer material must be repaired
immediately in order to prevent the protective
material becoming damaged.
• If there is any doubt regarding whether the product is
fit for use, do not use.
• Make sure that you know how to use the product
before use.
• Always ensure the protective equipment is
properly fitted and maintained according to the
manufacturer's instructions.
• Do not change or remove parts on the product. Only
perform changes that are listed in the operator's
manual.
• Keep the garment away from sharp objects, acids,
oils, solvents, fuels and animal droppings.
• The garment should be cleaned every week if worn
daily. It should be washed immediately after use if
heavily soiled.
• Clean the garment immediately in case it has been
subjected to petrol, oil, grease or other flammable
materials. Fire hazard!
• Do not use other equipment which can be strapped
on the garment. Accessories can reduce the
protective capabilities.
• Carefully read and follow all instructions and
warnings of the power cutter you are operating when
wearing the equipment. Make sure to fulfill needs
related to training and competence to operate the
power cutter in a safe way.
• The jacket may not provide protection to the user
under all circumstances, especially not injuries
caused by impacts from the power cutter. The jacket
has been tested to provide some protection to chest,
shoulder and neck area that can reduce the risk of
laceration in the event of a kickback.
• For maximum personal protection, it is important that
the correct size is selected. Garments should be
3