Changing The Remote-Control Battery; Turning The Screen On And Off - Legamaster Panorama PAN-10500 User Manual

OVERVIEW / OPERATING THE SCREEN

2.4.1 CHANGING THE REMOTE-CONTROL BATTERY

1. Remove the battery cover:
On the backside of the remote-control, slide down the battery cover.
2. Insert batteries:
Use two AAA batteries and insert them according to the plus and minus indicators in the remote control.
3. Close the battery cover by sliding it back into place.
I. Discard batteries according to the local waste reduction and recovery regulations.
II. Do not keep used, empty batteries in the remote control. They can leak and result in damages to the
remote control.
III. Only use batteries according to the instructions and regulations found in this manual and to the
instructions and regulations set forth by the batteries' manufacturer.
About the remote control
• Do not drop, shake, or bump.
• Avoid moist conditions, liquids, high-temperatures and/or exposure to direct sunlight.
• Don't dismantle.
3. TURNING THE DISPLAY ON AND OFF
Please make sure the display is connected to an AC power-socket using the supplied power cable.
Set the AC-switch to "l ". The Touch monitor will start up, if not.
To switch the display on, push the power button (left bottom back side of the screen) "O" on the screen
once, or push the power-button on the remote control.
To switch the monitor off, press the power button "O" on the screen or push the power button on the
remote control. The display will switch to stand-by mode.
To turn off power completely, turn the AC switch to "O "or disconnect the AC power cord from the power
outlet.
Product Content & Operation - Version 1.0
14