Panasonic ES-8151 Operating Instructions Manual page 6

(see fig. 11)
The batteries in this shaver are not
intended to be replaced by consum-
ers. However, the batteries may be
replaced at an authorized service
center. The procedure described be-
low is intended only for removal of
the rechargeable batteries for the
purpose of proper disposal.
1. Remove the screw (a) and the
bottom cover (b).
2. Slide the trimmer handle up until
it clicks in.
3. Remove the screw (c) and the
panel cover (d).
4. Remove the six screws (e).
5. Remove the back panel (f).
6. Lift the battery block (g) and re-
move it from the battery terminal
sealing (h).
7. Remove the batteries from the
battery block (g).
WARNING:
Do not attempt to replace the bat-
teries for the purpose of reusing
the shaver. This could result in the
risk of fire or electric shock.
• Do not charge the shaver where the
temperature is below 5°C (41°F) or
above 35°C (95°F), where it will be
exposed to direct sunlight or a heat
source, or where there is a lot of
moisture.
• Use only the included adaptor
RE7-05 to charge the ES8151/
ES8152 shaver.
• Dry the shaver completely before
charging it.
• Keep the adaptor away from water
and handle it only with dry hands.
• The charge status lamp may not
glow for several minutes after
charging has commenced but will
glow if charging is continued.
• Grip the adaptor when disconnect-
ing it from an AC outlet; tugging on
the power cord may damage it.
• Store the adaptor in a dry area
where it will be protected from dam-
age.
• Do not pull, twist, or severely bend
the power cord.
• Do not wrap the power cord tightly
around the appliance.
• The linear motor of the shaver may
start operating without the On/Off
switch on if the shaver is placed
near a television, stereo, audio-
visual equipment or anything that
generates strong magnetic field.
Do not place the shaver near these
equipments.
• Wash the shaver in tap water. Do
not use salt water or boiling water.
Also, do not use cleaning products
10
10
that are designed for toilets, bath-
rooms or kitchen appliances. Do
not submerge the shaver for a long
time.
• Do not wipe any part of the shaver
with thinner, benzine or alcohol.
Clean it by using a cloth dampened
with soapy water.
• Do not take the housing apart as
this can affect the watertight con-
struction.
• Do not clean with water when the
shaver is connected to the power
cord.
• Do not shave when the "sonic" vi-
bration is activated, as it may dam-
age your skin.
• When cleaning the shaver with
water, do so with both the inner
blades attached. (Doing so with
only one of the inner blades at-
tached makes an abnormal noise
and may damage the shaver.)
Power source: 100-240V AC,
50-60 Hz (Automatic voltage conver-
sion)
Motor voltage: 2.4 V DC
Charging time: 1 Hour
This product is intended for house-
hold use only.
11
11