Dri-Eaz 110128 Quick Start Manual

LEGEND BRANDS, INC. | 15180 Josh Wilson Road, Burlington, WA 98233 | Phone: 800-932-3030 LegendBrands.com
WARNING
ADVERTENCI
WARNING! Do not alter or modify your unit in any way.
Use only replacement parts authorized by Legend
Brands. Modifications or use of unapproved parts could
create a hazard and will void your warranty. Contact
your local distributor for assistance.
WARNING! Explosion or combustion hazard due to
flammable refrigerant.
• Do not drill into or braze the dehumidifier.
• Do not attempt to service the refrigeration system! Only
authorized service personnel should service the
refrigeration system.
• Be aware that refrigerant gases can be odorless.
WARNING! Electric shock hazard, rotating fan, hot
surface hazards. Unplug unit before opening cover
for cleaning or servicing. Unit must be grounded.
• Inspect the power cord before use. If cord is damaged, do
not use. Always grasp the plug (not the cord) to unplug.
• Insert three-prong plug on power cord into a matching
electrically grounded outlet. Do not use adapter. Never cut
off third prong. Do not use an extension cord.
• The unit must be operated on a 120V/60Hz circuit
protected by a Ground Fault Circuit Interrupter (GFCI)
device.
• Keep motor and wiring dry.
• Do not attempt to repair the unit. For Authorized Service
Centers, contact Legend Brands.
NOTICE: Do not use in environments where corrosive
chemicals are present, such as chlorine.
NOTICE: The unit should not be used by persons (including
children) with reduced physical, sensory or mental capabilities,
or lack of experience and knowledge, unless they have been
given supervision or instruction. Children should not be allowed
to play with the unit.
For proper disposal, this unit should be taken to a recycler
licensed to process refrigeration equipment.
127074A (#110128/#110133 – QSG)
Quick Start Guide
LGR 2800i Dehumidifier
LGR 3500i Dehumidifier
Patents:
Item #110128 & #110133 |
http://www.LBpatents.com
OPERATING YOUR DEHUMIDIFIER
Set unit upright
NOTICE: Do not transport or store the unit in a
horizontal position, as doing so can possibly damage the
unit. If the unit has been placed in a horizontal position,
set it upright and let it stand for at least 30 minutes
before turning it on.
Set up drain hose
Unwrap the entire hose and place the unattached end in
a sink, drain, bucket or outdoors – anywhere that water
can drain out safely. If you use a bucket or other
container, check it regularly to prevent overflows.
NOTICE: Uncoil and straighten the entire drain hose. Do
not leave any part of the hose coiled on the unit and do
not place the end of the hose higher than 20 ft. (6 m)
above the bottom of the unit.
Plug in electrical cord
The dehumidifier should be plugged into a GFCI-protected 120
volt outlet rated for at least 15 amps.
AT THE END OF THE JOB
NOTICE: To ensure all water is removed from the
dehumidifier, the unit will complete the defrost cycle
even if the unit is turned off. Do not unplug the unit
during the defrost cycle, and keep it upright on a
horizontal surface until all water has been purged.
1. Do not turn unit off or move it until it has returned to
normal operating mode.
2. Gently rock the machine to ensure any water
remaining on interior surfaces falls into the sump area.
3. Press the PURGE key. When the purge cycle is
complete, turn the unit off.
4. Coil power cord and hose and place it in the storage
pockets.
WARNING: This product may expose you to
chemicals, including lead and phthalates, known to the
State of California to cause cancer, birth defects, or other
reproductive harm. For more information, go to
P65Warnings.ca.gov
CONTAINS: FCC ID 2ADHKWINC3400; IC 20266-
ATWINC3400; CAN-ICES-003(B)/MB-003(B)
1 Legend Brands, Inc.