Exchanging The Cover Strip For Series Axc - NTN-SNR AXC Series Operating Manual

www.ntnsnr.ru snr-mail@ya.ru Тел.: (499) 703-40-50
Sealing strip replacement – AXC series
First loosen and remove the screws (a) in the carriage to remove the slide plate (b). The belt clamping on the
axis ends can then be loosened. With toothed-belt axes, the sealing strip is clamped by the end position
damper (c) and loosened by removing the cap screw (d) (fig. 12). Ball screw drive linear axes feature a belt
clamping through a sheet (e) that can be removed by unscrewing the retaining screws (f) (fig. 11).
The old sealing strip (g) can then be removed and replaced with a new one.
Please always indicate the linear axis serial number when ordering a replacement sealing strip so it
can be cut to the exact length of the respective profile to achieve an optimum sealing.
e
f
g c
d
b
a
Fig.11
Fig.12
Prior to mounting the new masking belt, it must be ensured that the pressure roller in the slide plate and the
guide rollers in the carriage section can be slightly turned on the steel pins. The pins should be cleaned or
replaced, if necessary (fig. 13).
Fig.13
19