Notice For Linear Axis Start-Up - NTN-SNR AXC Series Operating Manual

www.ntnsnr.ru
Two mounting options are available for AXLT linear tables: either through direct bolting from above or with
pivoting T-nuts from the bottom of the table which may be freely positioned along the entire length (fig. 4).
Profile groove for
inserting t-nut
AXS series linear axes can also be affixed using T-nuts as well as with (custom made) adapter plates if
required to level surfaces or other NTN-SNR linear axes.
The number of fastening points should be verified in terms of application for all mounting types. It must be
ensured that any resulting deflection of the profile or system neither impedes performance and/or required
accuracy.

Notice for linear axis start-up

Linear axes can travel at high speeds with a large degree of force. Carriage fittings can lead to bodily injury
or material damage upon collision. Start-up should thus be performed with the utmost caution.
Furthermore, it should be ensured upon start-up that the permissible loads are not exceeded and the carriage
fittings are securely fastened. It should also be ensured that the maximum possible travel is not exceeded.
If travel is limited with limit switches, they should be previously tested in terms of performance and correct
positioning.
Hazards can arise through unintentional descending of vertical linear axis. The end user must take the
necessary precautions. We recommend to use the Fachausschuss information sheet Nr. 005 „ Gravity-loaded
axes (Vertical axes)" issue 02/2004 from Fachausschuss Maschinenbau, Fertigungssysteme, Stahlbau
(Germany).
The manufacturer is not liable for damages resulting from non-observance of these start-up
instructions. The user bears sole responsibility for all risks.
snr-mail@ya.ru Тел.: (499) 703-40-50
8
Counterbore for
bolting from above
Fig. 4