Lightspeed MEDIA CONNECTOR Manual

Pairing your Microphone

Your system is shipped with microphones and base units pre-paired for quick and easy use. If
for any reason you need to pair new components, follow this pairing process:
PLEASE NOTE: Microphones should be out of the charger while pairing.
1. From a powered off state,
point the IR transmitter lens
toward the base unit (for
Sharemike, the transmitter lens
is located on the back of the
microphone).
FLEXMIKE
POWER
MIC 1
2. Press and hold the power
button for 5 seconds until the mic
1 and mic 2 lights start flashing,
then release the button and let the
pairing process finish.
REDCAT
IR TRANSMITTER
MIC 2
3. The "status" light on the base
unit will light up indicating the
pairing process is complete.
The mic 1 or mic 2 light on the
microphone will stay illuminated.
IR TRANSMITTER
MIC 1
POWER
BACK
SHAREMIKE
MIC 2
FRONT