Page 1
USER Manual Page 1 of 65 5G gateway 500G User manual 5G-500G Wireless mobile Internet Access Device via 5G With WiFi 802.11b/g/n/ac/ax LIGHTSPEED International Co. VERSION: V.1.0 Technical Support:peter@lightspeed.com.tw TEL: +886-3-5396750 www.lightspeed.com.tw...
USER Manual Page 2 of 65 Table of contents Table of contents ........................... 2 FCC Warning Message: ........................ 3 Copyright ............................4 INTRODUCTION ........................5 BRIEF INFORMATION ......................6 SETTING YOUR PC ENVIRONMENT ................15...
USER Manual Page 3 of 65 FCC Warning Message: Any changes or modifications not expressly approved by the party responsible for compliance could void your authority to operate the equipment. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
This document is the property of LIGHTSPEED and implies no license under patents, copyrights, trade secrets. No part of this publication should be copied, reproduced, stored in a retrieval system, or transmitted, in any form or by any means (electronic, mechanical, photographic, or otherwise) without the prior permission of LIGHTSPEED.
USER Manual Page 5 of 65 INTRODUCTION 1.1. OVERVIEW 5G gateway 500G is a wireless mobile internet access device with 4 ports 10/100/1000 Mbps Ethernet interfaces, 1 port 2.5Gbps WAN and 802.11b/g/n/ac/ax to performwireless internet service between PC and wireless WAN via5G Cellular station. 5G gateway 500G incorporates a 5G modem, SoC, system memories, 4 Giga LANs, 1 2.5Gbps WAN 802.11 b/g/n/ac/ax, Embedded OS, various network protocols for wireless internet.
USER Manual Page 6 of 65 BRIEF INFORMATION 2.1. APPEARANCE Below arethe appearance and the each part of name of 5G gateway 500G. Figure 1: Each part’s name of 5G gateway 500G - front view Figure 2: Each part’s name of 5G gateway 500G - rear view 2.2.
Page 7
USER Manual Page 7 of 65 2.3.1. WPS(Push button)Wi-Fi Protected Setup (WPS) is designed to make the process of connecting to a secure wireless network from a computer or other device easier. 2.3.2. Reset (Push button) It is software reset for5G gateway 500G. 2.3.3.
Page 8
USER Manual Page 8 of 65 Indicates WAN connected. Green BLINK Indicates data are existed via WAN. Indicates WAN disconnected. 2.2.13 LEDWPS State Description Indicates WPS is press Green BLINK Indicates data are existed via WPS Indicates WPS is off. 2.2.14 LED ZB BT State Description...
Page 9
USER Manual Page 9 of 65 2.2.18 CELL5G ANT1, ANT2, ANT3, ANT4 Cellular 5G antennas with SMA connectors. These connectors ANT1, ANT2, ANT3 & ANT4 should be connected to 5G antennas. 2.2.19 ZIGBEE BT ANT 1 fix 2.4GHz antenna for Zigbee & Bluetooth(optional)
Page 11
USER Manual Page 11 of 65 2.5. SOFTWARE COMPOSITION. 2.5.1. OpenWRT Web-based configuration page 5G gateway 500G has a OpenWRTweb-based configuration page that user can set the options of 5G gateway 500G for user’s purpose. This version namewill be changed whenever this is updated.
Page 12
USER Manual Page 12 of 65 BEFORE USAGE 2.6. 2.6.1. Installation 5G gateway 500G is a wireless mobile internet access device with PC or other LANdevices via 5G mobile station. Please follow below steps when you install this device. 2.6.1.1. Turn off power before Inserting U-SIM card. 2.6.1.2.
Page 13
USER Manual Page 13 of 65 Checking device 5G gateway 500G is set by PPP (NAT Router) in the first time. When you get this device in the first time, please check whether this device is correct or not. Please follow below steps to check this device seeing the 11-Status LED’s operation. 2.6.2.
Page 14
USER Manual Page 14 of 65 2.7. Understanding basic operation 2.7.1. Mobile Gateway mode On Mobile Gatewaymode, 5G gateway 500G has an IP from ISP(Internet Service Provider) then 5G gateway 500G keeps the IP and shares the IP with connected Host PC via NAT.
USER Manual Page 15 of 65 SETTING YOUR PC ENVIRONMENT 3.1. SETTING HOST PC 3.1.1. 5G gateway 500G is set byModem routermode/Always On-lineat first time. So just connect an LAN cable (Direct) between your PC and LAN port of 5G gateway 500G. Set the network environment of your PC as automatically.
Page 16
USER Manual Page 16 of 65 3.1.2.3. Double click the “Internet Protocol [TCP/IP]” item. Figure 6: Step 3 of setting your PC’s network environment 3.1.2.4. Check the “Obtain an IP address automatically” . Figure 7: Step 4 of setting your PC’s network environment 3.1.2.5.
Page 17
USER Manual Page 17 of 65 3.2. Configuration interface 3.2.1. This web-based configuration are give you to easily program the 5G gateway 500G 3.2.2. How to access Lunch the web browser and puthttp://192.168.1.1on the address filed in browser than pop-up login page like follow Default login credential is User name: root Password:...
Page 31
USER Manual Page 31 of 65 Realtime Graph It shows login graphs.
Page 32
USER Manual Page 32 of 65 3.3. System Select System, it will show currently running system processes & their status. 3.3.1. Administration This shows current firmware version, memory size ..etc.
Page 33
USER Manual Page 33 of 65 3.3.2 Software...
Page 34
USER Manual Page 34 of 65 3.3.2. Startup...
Page 35
USER Manual Page 35 of 65 3.3.3. Scheduled Tasks...
Page 36
USER Manual Page 36 of 65 3.3.4. LED Configuration...
Page 37
USER Manual Page 37 of 65 Please keep your PIN code in safe place. If it fails 3 times, SIM card will be block by Operator. Then you will need to ask service provider to give you PUK code to unlock SIM.
Page 38
USER Manual Page 38 of 65 3.3.6. Reboot 3.4.1 Under service, select Dynamic DNS...
Page 39
USER Manual Page 39 of 65 3.4.2 OpenVPN...
Page 40
USER Manual Page 40 of 65 3.4.3 Select UPnP...
Page 41
USER Manual Page 41 of 65 3.5 Under network, select Interface.
Page 42
USER Manual Page 42 of 65 3.6 Select WiFi.
Page 43
USER Manual Page 43 of 65 3.7 Select Switch.
Page 44
USER Manual Page 44 of 65 3.8 Select DHCP & DNS...