Configuring And Connecting Ac Power - M-Audio DSM1 User Manual

Configuring and Connecting
AC Power
Be sure to follow the instructions in this section
for the proper configuration of fuses and voltage
settings.
DSM1 speakers must be manually config-
ured for the voltage in your area. Always
check the voltage setting and fuse rating, as
described below, before connecting and
powering your speakers.
Setting the Voltage
Make sure the Voltage Selector setting on each
speaker matches your local voltage (100–120V
or 220–240V).
Voltage
selector
Voltage selector
Installing a Fuse
A 2.5 Amp fuse is required for both the
100–120V and the 220–240V settings.
Make sure to use a fuse rated at 2.5 Amps.
Do not use fuses of any other rating, or you
risk damage to the unit
To change the fuse:
Turn off power to the speaker and disconnect
1
the AC power cord.
Use a small screwdriver to remove the fuse
2
holder.
Fuse holder
Remove the currently installed fuse.
3
Install the new fuse in the fuse holder.
4
Replace the fuse holder so that it clicks into
5
place.
Chapter 3: Setup and Operation
Fuse
holder
9