BaByliss CREATIVE ST410E - Easy Straightening Short Hair Manual

Table of Contents

Contents

1 OVERVIEW
2 USE
3 MAINTENANCE
4 Documents / Resources
- 4.1 Download manual

OVERVIEW

Please read the safety instructions prior to use.

Overview

Straightener ST410E has the following technical specifications:

24 mm × 100 mm floating plates: use these to slide and manoeuvre the straightener, placing constant pressure on the hair but not damaging it (1)
Ceramic coated plates
On/off slide switch (2)
Rapid temperature setting (230°C)
Indicator light (LED) (3)
Swivel cord (4)
Plate locking system for optimum protection and storage (5)

USE

Plug in the appliance and switch it on. Allow it to heat up for about 90 seconds.
Carefully untangle the hair and divide it into sections. Start with the lower sections of hair. Take a section about 5 cm wide and place it between the 2 heating plates, ensuring that you do not touch the heating plates with your hand. Close the straightener and hold it to keep the hair in it, then slide it slowly from the roots to the ends. Let the hair cool down before you comb it.
After use, switch off the appliance. Unplug the appliance. Allow to cool before storing.

Hairstyling tips: To work the ends inwards, gently turn the straightener inwards, sliding it at the same time. Once you have reached the ends, hold it in place for a few seconds, and then relax. To work the ends outwards, move it in the same manner the other way.

information Notes:

Place the appliance on a heat-resistant surface. The appliance is designed with an integrated support to be placed and stood upright while heating.
The first time you use the appliance, you may notice an odour: this is quite normal and it will disappear the next time you use it. N.B.: When you are straightening, you may see some steam. This could be because of evaporation of the natural oils of the hair, residual hair products (leave-in hair products, hairspray, etc.) or excess moisture evaporating from your hair.
It is possible to use a heat protection spray for optimal protection of the hair.
If the straightening is not effective enough, press the plates on the section more firmly, slide the appliance more slowly, and raise the temperature.

MAINTENANCE

Unplug the appliance and allow to cool completely.
Clean the plates using a soft, damp cloth, without soap, to preserve the optimal quality of the plates. Do not scratch the plates.
To protect the plates, store the straightener with the plates closed tightly.