Advertisement
Table of Contents
Installing the board in a Multi-Format Camera
1 Remove the left and right side panels on the Multi-Format Camera (AK-HC930P).
2 Remove the blank panel (right side of camera), then feed the cable (supplied with the
board) through the rectangular opening under the top panel and insert it into the
connector on the opposite side.
CAUTION:
These servicing instructions are for use by qualified service personnel only. To
reduce the risk of electric shock do not perform any servicing other than that
contained in the operating instructions unless you are qualified to do so.
Connector
Insert the cable into the connector on the opposite
(left) side of the camera(inside of the heat sink).
Rectangular opening
Blank panel
5
D O W N
C O N V
7
Down Converter Board
Model No. AK-HDC930P
Heat sink
8
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Panasonic AK-HDC930
Summary of Contents for Panasonic AK-HDC930
- Page 1 Installing the board in a Multi-Format Camera 1 Remove the left and right side panels on the Multi-Format Camera (AK-HC930P). 2 Remove the blank panel (right side of camera), then feed the cable (supplied with the board) through the rectangular opening under the top panel and insert it into the connector on the opposite side.
- Page 2 3 Insert this board (down converter unit) into slot 6 of the camera’s circuit board. 4 Insert the other end of the cable into the connector on the board itself. Printed in Japan VQT0G78 D O W N C O N V Down converter board D O W N C O N V...
Need help?
Do you have a question about the AK-HDC930 and is the answer not in the manual?
Questions and answers