Back Panel Connectors - Gigabyte MZ73-LM0 User Manual

1-6

Back Panel Connectors

Server Management LAN Port
u
The LAN port provides Internet connection with data transfer speeds of 10/100/1000Mbps. This port is
the dedicated LAN port for Server Management.
USB 3.2 Gen1 Ports
v
The USB port supports the USB 3.2 specification. Use this port for USB devices such as a USB
keyboard/mouse, USB printer, USB flash drive etc.
LAN Port #1
w
The Gigabit Ethernet LAN port provides Internet connection at up to 10 Gbps data rate. See the section
below for a description of the states of the LAN port LEDs.
LAN Port #2
x
The Gigabit Ethernet LAN port provides Internet connection at up to 10 Gbps data rate. See the section
below for a description of the states of the LAN port LEDs.
COM1
y
VGA Port
z
Connect to a monitor device.
ID button with LED
{
When the system identification is active, the ID LED on the front/ back panel glows blue.
LAN and ID Button LEDs
Link/Activity LED
Speed LED
LAN Port
• When removing the cable connected to a back panel connector, first remove the cable from your
device and then remove it from the motherboard.
• When removing the cable, pull it straight out from the connector. Do not rock it side to side to
prevent an electrical short inside the cable connector.
1
3 4
2
10GbE LAN LED:
State Description
Yellow On 5Gbps, 2.5Gbps, 1Gps data rate
Green On 10Gbps data rate
Off 100Mbps data rate
ID button/LED:
State Description
Blue On System identification is active
Off System identification is disabled
Hardware Installation
5 6
- 19 -
7
10/100/1000 LAN LED:
State Description
Yellow On 1Gbps data rate
Green On 100Mbps data rate
Off 10Mbps data rate